The anti-loss lip is suitable for pre-assembly. With sealing capabilities. Resistant to corrosion and many chemicals.
Retainer Rings are installed into pre-manufactured grooves on axles to act as a shoulder and retain a specified component or assembly. These retainers are designed with a lip for easy assembly and dismantling. These can be found in POM material.
Flat Washers are used in conjunction with Screws, Bolts or Nuts. They offer insulation, spacing and load distribution for your assemblies. A wide selection of materials including Polyamide (PA /Nylon), Polycarbonate (PC) and PVDF are offered that support a wide range of applications, including within the Electrical and Medical industries.
Finishing washers have good insulation properties, are a high-quality finish and give excellent protection against damage to your application.
Shoulder Washers are designed to provide electric and heat insulation in assemblies where this is a crucial requirement. Made from a variety of materials and colours, these products are self lubrication, corrosion and abrasion resistant.
Saddle washers are designed to accommodate pipes and tubes, and offer support to the pipe assembly during installation and application. They are manufactured in PA 6 in a black or natural, and will not cause damage to painted surfaces.
Flat Thermoplastic Rubber (TPR) Washers are designed for use with Screws, Bolts or Nuts in applications where vibration dampening and improved chemical resistance are required. Additionally, fitted TPR Washers offer excellent sealant properties that make them ideal for use in the Oil and Gas and Automotive industries.